|
OSHA
ACCEPTED
One man can now
lift 500 lb. loads up to 20 ft. in two minutes or less - this
can be done with the Model 520A Lift. This
unit is equipped with guy cables, outrigger bars, and adjustable
wing-screw levers with sturdy rubber feet to stabilize the
load. If used on bare ground, wood buckets should be placed
under casters and levers. To move the unit on hard
surface, simply raise the rubber footed levers slightly to
allow the swivel casters to turn freely.
Where intermediate
heights are desired, the model is quickly converted to a 16,
14, 10 or even a 5 ft. lift, either by
removing or replacing the proper post sections. 2 ft. post
section shown in specifications page provide for all inter-
mediate heights in 2 ft. increments. When the MODEL 520A is
assembled as a 5 ft. lift, it can be tipped back on the
corrugated handle and rolled into a truck or Van.
WARNING:
DO NOT USE EXTRA POSTS TO INCREASE THE DESIGNED MAXIMUM HEIGHT
OF
20' ON THE MODEL 520A LIFT.
|
