An economical and versatile alternative to a sit-down forklift.
CAPACITY  2,200 lb at 24” load center
LIFT HEIGHTS  118 inches  130 inches
OPERATION/CONTROLS  Thumb throttle, lift, lower, rapid lower, horn and      reversing switch are easily located on the ergonomically      correct top mount handle  On/Off key switch, emergency power cutoff switch      and hour meter/battery discharge indicator mounted      on dash  Clear view mast with exterior lift cylinders for excellent      forward visibility  Automatic neutral braking on throttle release  Braking activation at top and bottom of handle      working range

DRIVE SYSTEM  High performance vertically mounted Curtis SepEx™     separately excited motor provides maximum torque     throughout entire travel speed  Precision helical drive gears provide quiet operation     and transfers power more efficiently from drive motor     to axle  Long life electromagnetic braking system
HYDRAULIC SYSTEM  Lifting rams are hard chromed plated for long life     and mounted outboard of lifting mast for even load     lifting  Pump unit, motor and solenoid actuated, pressure      mounted outboard of lifting mast for even load lifting
	WHEELS  Low effort steering with center drive tire and     stabilizer wheels  9.8” x 3.0” rubber drive wheel  6.3” x 3.2” polyurethane load wheels  4.0” x 2.3” polyurethane stabilizer wheels
ELECTRICAL SYSTEM  24 volt  State-of-the-art programmable Curtis transistor motor     controller provides smooth and seamless travel  Auto reset circuit breaker and fused control circuit     designed to protect the electrical system
	OPTIONAL EQUIPMENT  Consult us.
FORKS/CHASSIS  42” long forged forks, 23”OD adjustment on ITA     class II carriage  Dual cylinder 3 forward & 6 backward mast tilt  Channel mast fitted with heavy-duty roller bearings     and dual lift chains  32” high load backrest

		Be A Safe Operator.
		• Do not operate this truck unless you have been trained and    authorized to do so. • Do not operate this truck until you have checked its    condition. Give special attention to tires, battery, controls,     lifting systems (including switches), brakes, steering     mechanism, guards and safety devices. • Report the need for truck repairs to your supervisor    promptly. Do not operate the truck. Neglect may cause a    minor repair to become a major service problem or cause    the truck to become unsafe. • The powered lift stacker is intended for use on level    surfaces only. • Do not exceed the rated capacity of the vehicle as marked    on the nameplate. Do not lift with the fork tips or one fork    only, and be sure load is centered and the 24”(610mm)    load center is not exceeded. • Do not handle unstable or loosely stacked loads. Use    special care when handling long, high or wide loads, to    avoid tipping, loss of load, or striking bystanders. • Always look in direction of travel. Keep a clear view    and when load obstructs visibility, travel with load trailing    (except when climbing ramps). • Watch swing clearance when turning near walls, racks,    pillars or other obstacles. • Start, stop, change direction, travel and brake smoothly.    Slow down for turns and on uneven or slippery surfaces    that could cause truck to slide or tip. Be aware that the truck    behaves differently without a load than with a load. • Observe applicable traffic regulations and yield right of way    to pedestrians. Slow down and sound horn at all aisle     intersections and where vision is obstructed.    Do not ride on truck unless equipped with a rider platform. • Do not carry passengers.

Back to Product Page