XPL SERIES POWERED LIFT MEDIUM DUTY STACKER
An ideal straddle workhorse for pallet handling and stacking applications. Available in 3,000 lb and 3,500 lb capacities with lift heights up to 157" (3,988mm) to tackle your materials handling applications.
CAPACITIES	LIFT HEIGHTS
• 3,000 LB at 24” load center • 3,500 LB at 24” load center	• 130 inches • 142 inches • 157 inches
OPERATION/CONTROLS • Thumb throttle, lift, lower, horn and reversing switch are    easily located on the ergonomically correct top mount handle • On/Off key switch, emergency power cutoff switch and hour    meter/battery discharge indicator mounted on dash • Clear view mast with exterior lift cylinders for excellent     forward visibility • Automatic neutral braking on throttle release • Braking activation at top and bottom of handle working range
DRIVE SYSTEM • High performance vertically mounted Curtis SepEx™    separately excited motor provides maximum torque    throughout entire travel speed • Precision helical drive gears provide quiet operation and    transfers power more efficiently from drive motor to axle • Long life electromagnetic braking system
HYDRAULIC SYSTEM • Lifting rams are hard chromed plated for long life and    mounted outboard of lifting mast for even load lifting • Pump unit, motor and solenoid actuated, pressure    compensated lowering valve are easily accessible
FORKS/CHASSIS • 42” long forged forks, 38” OD adjustment on ITA class III   carriage • Straddle legs adjust to three (3) positions for varying pallet    sizes • Channel mast fitted with heavy-duty roller bearings and    dual lift chains • 48” high load backrest
			Easy Access Controls		Adjustable Straddles	Easy Battery Access
			WHEELS • 3” diameter polyurethane load wheels • 7” diameter nylon pivot steer wheels
			OPTIONAL EQUIPMENT • Consult us
ELECTRICAL SYSTEM • 24 volt system • State-of-the-art programmable Curtis transistor controller motor    provides smooth and seamless control • Auto reset circuit breaker and fused control circuit designed to    protect the electrical system

SPECIFICATIONS
	Be A Safe Operator.
	• Do not operate this truck unless you have been trained and authorized to    do so. • Do not operate this truck until you have checked its condition. Give special    attention to tires, battery, controls, lifting systems (including switches),    brakes, steering mechanism, guards and safety devices. • Report the need for truck repairs to your supervisor promptly. Do not    operate the truck. Neglect may cause a minor repair to become a major    service problem or cause the truck to become unsafe. • The manual push stacker is intended for use on level surfaces only. • Do not exceed the rated capacity of the vehicle as marked on the    nameplate. Do not lift with the fork tips or one fork only, and be sure load    is centered and the 24”(610mm) load center is not exceeded. • Do not handle unstable or loosely stacked loads. Use special care when    handling long, high or wide loads, to avoid tipping, loss of load, or striking    bystanders. • Always look in direction of travel. Keep a clear view and when load    obstructs visibility, travel with load trailing (except when climbing ramps). • Watch swing clearance when turning near walls, racks, pillars or other    obstacles. • Start, stop, change direction, travel and brake smoothly. Slow down for    turns and on uneven or slippery surfaces that could cause truck to slide    or tip. Be aware that the truck behaves differently without a load than    with a load. • Observe applicable traffic regulations and yield right of way to pedestrians.    Slow down and sound horn at all aisle intersections and where vision is    obstructed. Do not ride on truck unless equipped with a rider platform. • Do not carry passengers.

Back to Product Page